Tell you how to do office scissors blunt

There are two main reasons why office scissors are dull for a long time. There are two reasons for the bluntness of scissors. One is that the contact surface of the blade is stained with too much dirt, and the second is that the surface of the blade may be slightly damaged, causing the cutting edge to “cut”. What if the ability is reduced and the office scissors are blunt? How to sharpen scissors? Using small items in daily life, such as eraser, baking soda, sunscreen, aluminum foil, etc., can make the scissors resurrect again. Let's take a look!

[The first move] from the blade contact surface is dirty, restore the scissors clean and yo!

In the simplest case, use an eraser to wipe the surface of the contact blade. If there is dirt that cannot be removed, use a cosmetic sponge to pick up a small amount of water, and use a little force to remove the blade surface. Dirty. In addition, you can use home baking essential baking soda powder to do cleaning, you can use wet sponge or cloth stained with baking soda powder and wipe the surface.

You can also use cream hair styling products, sunscreen, hand cream, etc. Apply to the blade's contact surface, then pick up the scissors and cut it, make sure that the contact surface is stained with cream, and wipe it off with toilet paper. If the stubborn adhesive is still too dry, apply it with a self-adhesive label remover before removing it.

[second stroke] Start with the damage of the knife face, restore the ability of the scissors to "cut"!

To restore the "cutting" force of the scissors, you can use scissors to cut the aluminum foil. Because aluminum is a kind of metal with a low melting point and a relatively soft type, the frictional heat and pressure generated when the scissors cut will melt the aluminum and attach it. The upper blade surface supplements the damaged part. When cutting aluminum foil, it is recommended to cut the wrinkled aluminum foil after it has been used. However, be careful not to have any other dirt on the aluminum foil.

The same principle, cutting aluminum cans is also possible, it is recommended to cut directly from the middle, but pay attention to the sharp incision aluminum cans, be careful not to cut hands. In addition, you can also cut the screwdriver. If you want to cut it, it is recommended to use a chrome-plated screwdriver with a smooth surface, and because you really want to cut and cut it, it's just like grinding and opening the scissors.

If you have pottery in your home, you can also use the scissors at the bottom of the pottery to grind along the fixed direction at an angle of 45 degrees to restore the sharpness of the blade. Alternatively, the pencil refill can be ground into a powder and then rubbed on the blade surface of the scissors to cut the friction, so that the abrasive can be easily used to polish the blade surface.

Restoration after restoration of scissors

If you want to cut the scissors better, use only a small amount of soap that you use in your daily life! After the soap is dried, hardened, and then pick up the soap and apply it to the blades of the scissors. Wipe again with a clean cloth. The soap oil will make the contact surface of the two blades more slippery and easier to use.

What to do if office scissors are blunt? To prevent the scissors from rusting, you can use a cork that has been pulled out of the bottle. Turn the cork in the middle of the blade and rub it off after washing it with water. The cork is not only a clean function, but The ingredients also prevent the rusting of the scissors, allowing the revived scissors to last longer.